I believe there's a webchat link somewhere in the README if you're not familiar with IRC. If you have other questions, or would like to talk in more real-time, please come to the IRC channel where we hang out, #Cakey on freenode. We're looking for a command that is not part of what has been normally observed that is used to tell the cart to respond to other flashcart commands, probably sent while it is in key2 mode. 8 bytes are sent as a command, with everything afterwards until CS1 goes high again being a response. ( wrote a protocol decoder for sigrok, but the gist of the protocol is: if CS1 is low, then it's a bidirectional parallel protocol that eventually transitions to use encryption (which the protocol decoder attempts to decode). Step 2: Download the latest R4 3DS Firmware kernel for your card. Card, but there was a noticeable difference. The original R4 Revolution DS Card looked much the same as the R4v. The original R4 DS Card, produced by the self- titled Team R4.

(I'm using a Action Replay with everything removed so that it just passes through the signals and has an additional way of breaking out the signals) You'll want at least D0-D7 and CLK, though it'd probably be preferable if you had CS1, CS2, and RST as well. Governed from factory with top speed of 18-20 mph, but can easily be adjusted to go 25. discovery guide R4 Sdhc V2 20T Kernel Download 0 Comments The Original R4 DS Card. Regardless: You'll want a way to break out the cart signals in order to have access to them while your console is communicating with it. (And if it can, could you point me towards the software you're using? Probably means I was doing something wrong with NTRPi) What is its sampling rate? You'll need something that can measure a protocol running at 4-6 Mhz.

R4 Sdhc V2 20T Kernel For R4I